Fujitsu Eternus DX600 S3 - Figure 1.9 Controller (ETERNUS DX600 S3)

● Controller (ETERNUS DX600 S3)
Figure 1.9 shows the controller of the ETERNUS DX600 S3.
Figure 1.9 Controller (ETERNUS DX600 S3)
1
3
2
4
7956 8
1. Host interface (CA#0)
Install host interfaces.
2. Host interface (CA#1)
Install host interfaces.
3. Host interface (CA#2)
Install host interfaces.
4. Host interface (CA#3)
Install host interfaces.
5. LAN (FST) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
6. LAN (RMT) port
These are the RJ-45 connectors to connect LAN cables.
7. LAN (MNT) port
These are the RJ-45 connectors to connect LAN cables.
8. DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a cable between enclosures.
9. PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
Chapter 1 Component Name/LED Name
1.1 Controller Enclosures
19
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0