Fujitsu Eternus DX600 S3 - Power Distribution Units (for Regions Other than EMEA&I); Power Distribution Units (1 U); Figure 1.35 Power Distribution Unit for DX500 S3;DX600 S3 (AC200-240 V, 1 U 4 Outlets)

1.5 Power Distribution Units (for Regions Other than EMEA&I)
There are two sizes for power distribution units: 1U and 2U.
1.5.1 Power Distribution Units (1U)
The 1U power distribution unit has four outlets and two inlets.
■
Power distribution unit for DX500 S3/DX600 S3 (AC200-240V, 1U 4Outlets)
Figure 1.35 Power distribution unit for DX500 S3/DX600 S3 (AC200-240V, 1U 4Outlets)
3
2
1
1.
Main line switch
This turns on and off the power distribution unit.
2. Outlet (OUTPUT)
This is a socket (IEC60320 C13) for outgoing power supply. This socket is used to connect a power cord (AC
output cable).
3. Inlet (INPUT)
This is a socket (IEC60320 C14) for incoming power supply. This socket is used to connect a power cord (AC
input cable).
Chapter 1 Component Name/LED Name
1.5 Power Distribution Units (for Regions Other than EMEA&I)
38
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0