Preface
Fujitsu would like to thank you for purchasing our FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage
system (hereinafter referred to as ETERNUS DX).
The ETERNUS DX is designed to be connected to Fujitsu servers (Fujitsu M10, PRIMEQUEST, or PRIMERGY) or
non-Fujitsu servers.
This manual describes the operation management and maintenance of the ETERNUS DX.
This manual is intended for use of the ETERNUS DX in regions other than Japan.
Please carefully review the information outlined in this manual.
Fourth Edition
June 2014
About This Manual
Organization
This manual is composed of the following six chapters:
•
"Chapter 1 Component Name/LED Name" (page 12)
This chapter provides component names of the ETERNUS DX500 S3/DX600 S3 Disk storage system.
•
"Chapter 2 Basic Operation" (page 40)
This chapter explains how to open and close rack doors and how to turn the ETERNUS DX500 S3/DX600 S3
Disk storage system on and off.
•
"Chapter 3 Storage System Monitoring" (page 50)
This chapter describes status monitoring of the ETERNUS DX500 S3/DX600 S3 Disk storage system.
•
"Chapter 4 Process Time (Estimated)" (page 54)
This chapter explains the estimated time that is required for volume formatting and for rebuild/copyback
for each RAID level configuration.
•
"Chapter 5 Expansion Functions" (page 57)
This chapter explains the expansion functions of the ETERNUS DX.
•
"Chapter 6 Maintenance" (page 58)
This chapter describes maintenance once the ETERNUS DX starts to be operated.
•
"Chapter 7 Troubleshooting" (page 60)
This chapter explains troubleshooting when errors occur on the ETERNUS DX500 S3/DX600 S3 Disk storage
system.
3
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0
To Next Page
Loading...
