Fujitsu Eternus DX600 S3 - Components (Front); Figure 1.26 Operation Panel (High-Density Drive Enclosure); Table 1.11 Status and Meanings of each LED (Operation Panel (High-Density Drive Enclosure))

1.3.3 Components (Front)
This section describes the operation panel and the Disk Activity Panel (DAP) in the front of the high-density
drive enclosure.
■
Operation Panel
An operation panel has a DE-ID display and LEDs.
Figure 1.26 shows the operation panel. Table 1.11 shows the status and meanings of each LED.
Figure 1.26 Operation Panel (High-density Drive Enclosure)
2
1
3
4
1.
DE-ID
The DE-ID (drive enclosure number) of the drive enclosure is displayed.
2. IDENTIFY LED
3. FAULT LED
4. POWER LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 1.11 Status and Meanings of Each LED (Operation Panel (High-density Drive Enclosure))
LED name
LED status Meaning
IDENTIFY
(blinks blue)
The installation location of the drive enclosure is identified ac-
cording to the instruction that is issued from ETERNUS Web GUI or
ETERNUS CLI.
FAULT
(amber)
The drive enclosure is in error status.
POWER
(green)
DC power is supplied to the drive enclosure.
Chapter 1 Component Name/LED Name
1.3 High-density Drive Enclosure
30
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0