Fujitsu Eternus DX600 S3 - Powering on and off; Switching on and off the Main Line Switch on the Power Distribution Unit (for Regions Other than EMEA&I); Figure 2.1 on Position (Marked |) of the Main Line Switches on a 1 U Power Distribution Unit; Figure 2.2 on Position (Marked |) of the Main Line Switches on a 2 U Power Distribution Unit

2.2 Powering On and Off
This section explains how to turn on and off the ETERNUS DX.
2.2.1 Switching On and Off the Main Line Switch on the Power Distribution Unit (for
Regions Other than EMEA&I)
This section explains how to switch the main line switch of the power distribution unit to ON and OFF.
■
To Switch to ON
Turn the main line switch of the power distribution unit to the ON position (marked "|").
Make sure all of the main line switches are in the ON position.
● For 1U
Figure 2.1 ON Position (Marked "|") of the Main Line Switches on a 1U Power Distribution Unit
Main line switch
● For 2U
Figure 2.2 ON Position (Marked "|") of the Main Line Switches on a 2U Power Distribution Unit
Main line switch
Chapter 2
Basic Operation
2.2 Powering On and Off
43
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0