Fujitsu Eternus DX600 S3 - Powering on; Figure 2.6 off Position (Marked ¡) of the PSU Switch of a Power Supply Unit

■
To Switch to OFF
Turn the PSU switch of the power supply unit to the OFF position (marked "¡").
This does not need to be turned off for normal operation.
Figure 2.6 OFF Position (Marked "¡") of the PSU Switch of a Power Supply Unit
Power supply unit (PSU#0) Power supply unit (PSU#1)
Check that the POWER LED of the power supply unit is off.
2.2.3 Powering On
This section explains how to turn on the ETERNUS DX.
The following methods can be used to turn the power on:
•
Via the power switch
Press the Power switch to turn on the ETERNUS DX.
The following methods can be used to turn the power on by linking with the server.
•
Power Synchronized Unit
Use the power synchronized unit to turn on the ETERNUS DX.
•
Wake On LAN
Use the Wake On LAN function to turn on the power.
Before turning on the ETERNUS DX, make sure that the main line switches of the power distribution units
and the PSU switches on the power supply units of the ETERNUS DX are "ON". Do not turn the main line
switches of the power distribution units and the PSU switches on the ETERNUS DX to the OFF position.
Chapter 2
Basic Operation
2.2 Powering On and Off
46
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0