Fujitsu Eternus DX600 S3 - Figure 1.13 Power Supply Unit (Controller Enclosure); Table 1.5 Status and Meanings of each LED (Host Interface); Table 1.6 Status and Meanings of each LED (Power Supply Unit)

The states of LEDs are listed below.
Table 1.5 Status and Meanings of Each LED (Host Interface)
LED name LED status Meanings
CA FAULT
(amber)
The host interface is in error status.
CA READY
(green)
The host interface is in normal status.
LINK/FAULT
(green)
The link between the host interface port and the destination port
has been established.
(amber)
The host interface port is in error status.
■
Power Supply Unit
The power supply unit transforms input AC power from a power socket to DC power and supplies power to
each component.
Each power supply unit contains fans.
Figure 1.13 shows the power supply unit. Table 1.6 shows the status and meanings of each LED.
Figure 1.13 Power Supply Unit (Controller Enclosure)
3
2
1
1.
POWER LED
2. FAULT LED
3. Inlet
The LEDs turn on to indicate the statuses that are listed below.
Table 1.6 Status and Meanings of Each LED (Power Supply Unit)
LED name
LED status Meanings
POWER
(green)
AC power is supplied to the power supply unit.
FAULT
(amber)
The power supply unit is in error status.
Chapter 1 Component Name/LED Name
1.1 Controller Enclosures
22
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0