Fujitsu Eternus DX600 S3 - Figure 1.11 Host Interface (4 Port); Figure 1.12 Host Interface (2 Port)

■
Host Interfaces
A host interface is a board that has interface ports to connect a controller to the server.
Figure 1.11 and Figure 1.12 show host interfaces. Table 1.5 shows the status and meanings of each LED.
● Host Interface (4port)
Figure 1.11 Host Interface (4port)
4 5 6 7
12 3
1.
CA FAULT LED
2. CA READY LED
3. LINK/FAULT LED
4. Host Interface Port #0
This port is used to connect a host interface cable.
5. Host Interface Port #1
This port is used to connect a host interface cable.
6. Host Interface Port #2
This port is used to connect a host interface cable.
7. Host Interface Port #3
This port is used to connect a host interface cable.
● Host Interface (2port)
The following figure shows an example of when the host interface is FC.
Figure 1.12 Host Interface (2port)
4 5
12 3
1.
CA FAULT LED
2. CA READY LED
3. LINK/FAULT LED
4. Host Interface Port #0
This port is used to connect a host interface cable.
5. Host Interface Port #1
This port is used to connect a host interface cable.
Chapter 1 Component Name/LED Name
1.1 Controller Enclosures
21
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7742-04ENZ0