Working with the notebook
Wireless LAN / BlueTooth (device-dependent) /
UMTS (device-dependent)
The installation of radio components not approved by Fujitsu Technology Solutions
will invalidate the certifications issued for this device.
Switching the wireless components on and off
Before switching on your device for the first time, the on/off switch for
radio components must be in the "ON" position.
► Slide the O N/OFF s witc h into the "ON"
position to activate the radio components.
Wireless LANWirelessLA NBluetoothBl uetooth
or
► Slide the ON/OF F sw
itch to the
"OFF" position to
deactivate the
radio co m ponents
.
If you switch off the radio components, the wireless LAN tra nsmission unit (antenna)
and, if present, the Blueto oth and UMTS module will also be switched off.
You can enable and disable the installed radio components individually
using the WirelessSelector programme
You can also d eactivate the wireless c ompo nents individually in the BIOS Setup.
For th is to occur, you must either not ha ve assigned a supervisor password or if a
supervisor password has been assigned, you must know this password.
Pay attention to the additional safety notes for devices with wire less
components provided in the "Safety" manual.
Details on using Wireless LAN can be found in the online help system
included in the Wireless LAN software.
You can find more information on how to use Bluetooth on the CD you
received with your Bluetooth software.
You can obtain more information on UMTS from your service provider.
46 Fujitsu Technology Solutions
Downloaded from LpManual.com Manuals
To Next Page
Loading...
Need help?
General