Manufacturer’s notes
CE marking
CEmarking
CE markin g f or devices with rad io component
This equipment complies with the requirements of Dire ctive 1999/5/EC of the
European Parliament and Commission from 9 March, 1999 governing Radio
and Telecommunications Equipment and mutual recognition of conformity.
This equipment can be used in the following countries:
Belgium Bulgaria Denmark
Germany
Estonia Finland France
Greece
UK Ireland Iceland Italy
Latvia Liechtenstein Lithuania Luxemb ourg
Malta The
Netherlands
Norway Austria
Poland Portugal Rumania
Sweden
Switzerland Slovakia Slovenia Spain
Czech Republic
Hungary
Cyprus
Contact the corresponding government office in the respective country for
current information on possible operating restrictions. If your country is
not included in the list, then please contact the corresponding supervisory
authority as to w hether the use of this product is permitted in your country.
Regulatory notices
If the re is no FCC logo and also no FCC ID on the device then this device is
not approved by the Federal Communications Commission (FCC) of the USA.
Although it is not explicitly forbidden to travel in the US trading area carrying this
device, to avoid trouble at customs clearance, Fujitsu Technology Solutions GmbH
recommends not to bring this device into the US trading area.
Regulatory info rmation for no tebooks without radio device
Regulatoryinf ormation
NOTICE:
Changes or modifications not expressly approved by F ujitsu Technology Solutions
could void this user’s authority to operate the e quip ment.
Notice to Users of Radios and Television
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. Th is equipment generates, uses, and can radiate r adio frequency energy
and, if not installe d and used in accordance with the instruct ions, may cause harmful interference
to radio comm unications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
88 Fujitsu Technology Solutions
Downloaded from LpManual.com Manuals
To Next Page
Loading...
Need help?
General