Chapter 5 Troubleshooting
IP-9500e
64
11.
Is the IP address specified from the
Web browser correct?
Specify a correct IP address from the
Web browser on the control terminal.
12.
Are the network settings (IP
address, subnet mask, etc.) on the
control terminal PC correct?
Make correct settings by referring to the
PC user's guide and OS handbook. If this
device is started with the default settings
made before shipment from the factory, see
"Section 3.3.1, "Settings," for the network
settings for the control terminal PC.
13.
Device setting
through a LAN
is disabled.
Is a reply received in response to a
PING command issued to the IP
address of the device?
If a reply is not received, turn on the power
to the device while holding down the
Cancel key to start the system with the
default IP address (10.0.0.1) set before
shipment from the factory. Confirm the
IP address. If the problem persists, check
the status on the LAN. For information
on this startup procedure, see Section 3.6,
"Special Use of Cancel Key."
To Next Page
Loading...
