Chapter 3 Information About Software 35
RTIF1-
071116-006
O While XSCF is running, error message
of "hang-up is detected" might
be displayed to XSCF console, and
XSCF may reboot.
Check that XSCF is started. If not
started, use the rebootxscf(8)
command to restart XSCF, or stop all
the domains and then execute the
system power off/on (AC OFF/ON).
To turn on the system power that you
turned off, wait at least 30 seconds
before power-on.
RTIF1-
071129-001
O O If the following message is displayed
on XSCF console, the XSCF might not
start:
dbs[xxx]: ERR:
scdb_init_all(): xx, No space
left on device
In addition, this error log might be
registered:
XSCF process down detected
Replace the XSCF Unit.
RTIF1-
071129-002
O O When performing XSCF Shell
commands remotely using SSH on the
remote-control device, the following
messages might be displayed:
stty: standard input: Invalid
argument
None available at this time.
RTIF1-
071129-003
O O An error log cannot be registered in
XSCF when the following message is
displayed on Oracle Solaris OS by the
I/O error:
SUNW-MSG-ID: SUN4-8000-4P,
TYPE: Fault
No workaround is available.
RTIF1-
071129-004
O O The following messages are displayed
and you might not boot Oracle Solaris
OS:
• Abnormal OpenBoot
environment variable Boot
process failed
• ERROR: Invalid token ''
FATAL: NVRAM contents
corrupt; Reinitializing
NVRAM parameters.
Confirm the OpenBoot PROM
environment variable. If the variable
has errors, set the variable again.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
