34 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1121 • February 2016
RTIF1-
071011-001
O When the server is being installed,
and the mainline switch is turned on
for the first time, these error messages
might be displayed:
XSCFU hang-up is detected
XSCF process down detected
DB synchronization timeout
Turn off the system AC power, then
turn it on again.
RTIF1-
071102-001
O O The XSCF firmware monitors itself
and if it detects any inconsistencies, it
forces an XSCF reboot.
No workaround is available. Allow
the XSCF Unit to finish rebooting. It
returns to normal operation within
approximately 5 minutes.
RTIF1-
071102-002
OOOThe snmp daemon might quit. To restart the snmp daemon, issue the
command setsnmp enable.
RTIF1-
071116-001
O DR operations might fail (with a
misleading message regarding the
board being unavailable for DR) after
the addfru(8) or replacefru(8)
command have been used for active
replacement. This happens when the
active replacement is done without
the diagnostic test in the maintenance
menu.
Do not fail to execute the diagnosis in
the maintenance menu of the
addfru(8) or replacefru(8)
command. In case of missing the
diagnostic test in the maintenance
menu of the addfru(8) or the
replacefru(8) command, execute
the testsb(8) command or delete the
CPU/memory board unit using the
deletefru(8) command and then
retry the addfru(8) command.
RTIF1-
071116-003
O O Using the XSCF Web, when you
selected [COD], codusage details
cannot be displayed correctly.
Use showcodusage(8) command to
display the cod usage.
RTIF1-
071116-004
O O When Internet Explorer 7 browser is
used, the License key deletion cannot
be executed on the BUI COD page.
Use deletecodlicense(8)
command to delete a license key. Or
use other browsers:
• Microsoft Internet Explorer 6.0
• Firefox 2.0 or later
• Netscape Navigator 7.1 or later
RTIF1-
071116-005
O While system power on, when the
XSCF switching performed by
switchscf(8) command, PANIC
might be generated in XSCF before it
switches, and "SHUTDOWN timeout"
may be stored in the error log.
No workaround is available. This
message can be safely ignored.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
