Chapter 3 Information About Software 37
RTIF1-
080313-001
O O When you set XSCF as the NTP server
of the domain, following message
may appear on the domain console at
the domain start and you may fail to
perform time synchronization.
ntpdate[xx]: no server
suitable for synchronization
Perform either one of the following
workarounds depending on the mode
which has been set in the xntpd of the
domain.
Note - In case of step mode, the time
correction induces the time step.
When the time step occurred, it may
affect the applications running on the
domain.
• In case of step mode:
Specify the -w option to execute the
ntpdate(1M) command. Until it
succeeds in synchronizing with the
NTP server, the ntpdate command
retry continues at regular intervals.
In the retries, the message which
indicates that it failed to
synchronize with the NTP server
can be safely ignored. When the
synchronization completed, the
time will be corrected to the time of
the NTP server.
• In case of slew mode:
Execute the ntpdate(1M)
command without specifying the -
w option. In slew mode, the time
variance from the NTP server will
be corrected at 0.5 ms/second
intervals. The message which
indicates that it failed to
synchronize with the NTP server
can be safely ignored. Before the
time completely corrected, there
remains a time variance between
the NTP server and the domain.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
