Chapter 3 Information About Software 39
RTIF1-
080404-002
O O When you use the command
setsnmpusm passwd to set a
password, if you set a password of
fewer than eight characters, a
segmentation fault occurs.
Always set a password of at least
eight characters.
RTIF1-
080512-001
O O When you specify "localhost" to the
hostname of the sethostname(8)
command and reset XSCF by using
the applynetwork(8) and the
rebootxscf(8) commands, a process
goes down in XSCF.
Do not specify "localhost" to the
hostname of the sethostname(8)
command.
RTIF1-
080512-002
O When the NTP setting are enabled, a
message as follows may appear on the
XSCF console.
Output sample:
-xx.xxx.xxx.xxx mode 4 code
1 auth 0 clock_filter: n 8
off -0.000310 del 0.001300
dsp 0.001158 jit 0.000172,
age 0 clock_update: at
637535 assoc 2 local_clock:
assocID 54190 offset -
0.000309657 freq -9.765 state
4
...
This message can be safely ignored.
No workaround is available.
RTIF1-
080512-003
O O To a domain which is in Quad-XSB
configuration, when you perform
active addition of PCI cards and then
restart the domain, active addition of
PCI cards may become unavailable
afterwards.
Do not perform active addition of PCI
cards. When you failed in active
addition of PCI cards, stop the
domain to add on the cards.
RTIF1-
080520-001
O BUI Domain Operation page mistakes
the operation demand for Domain 8
or 9, and it issues it to DID#00
wrongly.
Do not perform active addition of PCI
cards. When you failed in active
addition of PCI cards, stop the
domain to add on the cards.
RTIF1-
080526-001
O O When the system is stressed with
many faults, the fmd process on the
service processor might hang. Once
this happens, fma commands on the
service processor can fail or hang.
Reboot the service processor using the
XSCF command rebootxscf(8).
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
