Chapter 3 Information About Software 51
RTIF1-
120611-001
O O When an External I/O Expansion Unit
error occurs with the following error
code, the showlogs(8) command may
fail to display an error message or the
component that needs to be replaced.
Code: XXXXXXXX-00XXXXXX-
11XXXXXXXXXXXXXX
No workaround is available.
RTIF1-
120703-001
O O There is a low probability that the
XSCF restart fails, when the XSCF
reset occurs due to an XSCF
malfunction.
No workaround is available.
If the defect occurred, contact a
qualified service engineer.
RTIF1-
121112-001
OOOAt the XSCF start, when the machine
administration of Enhanced Support
Facility (ESF) which operates in the
domain detected an error, process
failure may occur which leads to the
XSCF reset.
No workaround is available.
M4000/M5000/M8000/M9000
servers:
Check that XSCF is started.
If not started, stop all the domains
and then execute the system power
off/on (AC OFF/ON).
To turn on the system power that you
turned off, wait at least 30 seconds
before power-on.
M3000 server:
Check that XSCF is started.
If not started, stop the domain and
then execute the system power off/on
(AC OFF/ON).
To turn on the system power that you
turned off, wait at least 30 seconds
before power-on.
RTIF1-
121112-002
O When a temporary blackout occurred
on the M3000 server which is
mounted with the SPARC64 VII+
processor, the "Power subsystem
failure(detector=2)"
error is detected erroneously and the
domain may be suspended.
No workaround is available.
When this event occurred, power off
and wait at least 30 seconds before
power-on.
If not recovered with the above
workaround, contact a qualified
service engineer.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
