Fujitsu Stylistic Q702

Troubleshooting and tips
The Tablet PC stops working
TheTabletPCEnergy saving mode
Cause Troubleshootin g
The Tablet PC is in energy saving mode.
► Leave energy saving mode.
An application programme has caused the
malfunction.
► Close the application progr
am or restart
the Tablet PC (by restarting
the operating
system or switching the devi
ce off and back
on again).
The battery is dead.
► Charge the battery.
or
► Insert a charged batter
y.
or
► Connect the mains adapte r to the Tablet
PC.
The printer does not print
Printerdoe s notp
rint
Cause Troubleshootin g
The printer is not switched on. ► Make sure that t he printer is switched
on and ready for operation (refer to the
documentation s upplied with the printer).
The printer is not connected correctly.
► Check that the data cable connecting
the Table PC to the p rinter is properly
connected.
The printer driver is faulty or n ot correctly
installed, or it is th e wrong printer driver.
► Check that the data cable connecting
the Tablet PC to the printer is properly
connected.
► Check whethe r the correct printer driver is
loaded (refer to the printer documentation).
The radio connection to a network does not work
Theradi
oconnect i ontoa network doesnot w ork
Cause Troubleshootin g
The wireless compo nent is disabled.
► Switch the radio component on (see
"
Switch ing the wireless components on and
off", Page 42).
The wireless component is enabled. Despite
this, the wireless connection to a network doe s
not w ork.
► Check whether the radio connection is
switched on via the softwa re.
► Further information on using the radio
component can be found in t he help files.
69