Troubleshooting and tips
The wireless connection to a net
work does not work
Thewireless connection toanet workdoes notwork
Cause Troubleshoo ting
The wireless component is switched off. ► Switch the wireless component on (see
"
Switch ing the wireles s com ponents on and
off", Page 41).
The wireless component is switched on. Despite
this, the wireless connection to a netwo rk does
not w ork.
► Check whether the wireless connection is
enabled by the software.
► Furt her information on using the wireless
component can be found in t he help files.
The battery discharges
too quickly
Battery
Cause
Troubleshooting
The battery is either
too hot or too cold. In this
case the battery indi
cator flashes.
► Bring th e Tablet PC up/down to a normal
operating temperature again.
► If the operating time of the battery life is
extremely short, the battery is probably t oo
old. Replace the battery if necessary.
You m ay have an application running that
consumes a great deal of power due to frequent
accessing of th e hard disk or optical drive.
► Use the AC adapter whenever possible.
The maximum brightness may have been set
for the screen.
► Reduce the brightness of the screen to
lower energy consumption: You will find the
setting under Control Panel – Hardware and
Sounds – Wind ows Mobility Center.
Smart Card re
ader is not recognized
Cause
Troubleshooting
Smart Card inserted incorrectly. ► M ake sure you have inserted your Smart
Card into the Smart Card reader with
the chip facing upwards / downwards
(device-dependent).
► Check whether the Smart Card you are
using is supported. Your Smart Card must
comply with the ISO standard 7816-1, -2,
-3 and -4.
Smart Card PIN forgotten
Cause
Troubleshooting
PIN fo
rgotten
► If you
work in a network, contact your
syste
m administrator, who can unlock your
Tabl
et PC using a supervisor P IN.
Fujitsu 73
To Next Page
Loading...
