Fujitsu STYLISTIC V535 - RECOVER YOUR SYSTEM WHEN THE HARD DRIVE IS NOT BOOTABLE; Restore the Recovery Image for Full Hard Drive

Appendix
Determining whether Recovery and Utility is pre-loaded
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the Application Menu.
3. Check whether the Recovery and U tility option is present. If it is not present, it means
that the utility must be used from the Bootable Disk. Proceed to “Running Recovery and
Utility from the Bootable Disk” if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the Application Menu.
3. Cursor down to Recovery a nd Utility and press the
Enter
key.
4. Choose your language, if necessary. S elect R ecovery and Utility to proceed.
5. Three tool options appear: Diagnostics, Recovery,andUtility (refer to the Recovery and
Utility tools section below for instructions on how to use t hese tools).
6. If this was successful please skip the ne xt step and go to “Recovery and Utility tools. ”
7. If this was NO T successful, please go to the ne xt step.
Running Recovery and U tility from the Bootable disk
To verify/change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following steps:
1. Power o n your system. When the Fujitsu logo appears on the screen, press the
F12
key.
2. Insert the bootable disk into the drive tray.
3. Highlight the CD/DVD option f rom the Boot menu , then press
Enter
.
4. Click OK.
5. Select C D /DVD boot mode: UEFI Mode, if applicable, and then press
Enter
.
While the files are being loade d fro m the disk, the Fujitsu logo screen will appear
followed by a progress bar at the bottom of the screen.
96 Fujitsu