Some remarks related to the complete menu structure:
• When a certain cleaning system is loaded by choosing 'General' - 'Cleaning system'
then all default values for this system are loaded from memory. This procedure can
also be used to set all default values of a certain system
• Configuration of hardware in and outputs can be changed as much as needed, but
standard default connections are strongly recommended to keep support and service
more easily. Show vacuum pump run hours since last service: this possibility is
mentioned in Section 10.1.1
This information is presented by pressing: + . This value is calculated
by adding together the milking and cleaning durations. It can be reset by pressing:
+
To Next Page
Loading...