Fulton ProtoNode Start-up Guide
Page 9 of 47
3 PROTONODE SETUP
3.1 Record Identification Data
Each ProtoNode has a unique part number located on the side or the back of the unit. This number should
be recorded, as it may be required for technical support. The numbers are as follows:
Figure 1: ProtoNode Part Numbers
• FPC-N54 units have the following 3 ports: RS-485 + Ethernet + RS-485/RS-232
3.2 Point Count Capacity and Registers per Device
The total number of registers presented by the device(s) attached to the ProtoNode cannot exceed:
Figure 2: Supported Point Count Capacity
Hydronic_LMV3_And_Yokogawa
Figure 3: Registers per Device
To Next Page
Loading...
Need help?
General