APPENDIX
AP-18
Messages
Below are the various operational messages and their meanings. Messages are arranged
according to function key.
[F1] File
1. "Overwrite?"
You are asked if you are sure to overwrite file name entered.
2. "OK to save?"
You are asked if you are sure to save a file.
3. "OK to delete file?"
You are asked if it is OK to delete selected file.
4. "Can't delete."
File cannot be deleted.
5. "Enter new filename"
Enter a new file name (to save file under new name.)
6. "Can't rename."
Cannot rename file.
7. "Press any key to escape."
Press any key to erase message displayed.
8. " Drive not ready."
No floppy disk in disk drive.
9. "Write protected."
Floppy disk is write protected.
10. " Drive error."
Floppy disk may be defective.
11. "Directory not found."
Directory specified could not be found.
12. "Checking "
Checking MIME-coded file.
13. "Decode ?"
Decode Base64 coded file.
14. "Now decoding..."
Decoding file.
15. "Complete."
File decoding completed.
16. "Decode failed. "
File could not be decoded.
17. "This terminal not support this code."
File could not be decoded because type of code not supported.
18. "Decoded 1 file(s)."
Decode MIME coded file.
19. "This file is not encoding."
Cannot encode file selected.
20. "File is already exist. Overwrite?"
File name encoded by MIME already exists.
To Next Page
Loading...
