3. FILE OPERATIONS
3-19
3.10 Decoding E-mail Attachment
When you can't read an e-mail attachment because it has been coded by MIME
(Multipurpose Internet Mail Extensions), you may decode it as below.
1. Save the MIME-coded file to the hard disk. (See paragraph 4.2.5 for the
procedure.) This step is not necessary if Auto Receive Message Save is
turned on in the Auto Mode Setup menu.
2. Press the [F1] key to open the File menu.
3. Press the [9] key to choose MIME(Decode).
Decode window
4. Press the [↑] or [↓] key to choose the file you want to decode.
5. Press the [Enter] key.
MIME Decode
Checking 'E0970715.001'
. . .
Decode 'ABC.ini'?
Decode
Yes No
File chosen at step 4
File attachment
Decode window
6. Yes is selected; press the [Enter] key to decode the file.
Save window
To Next Page
Loading...
