Furuno FELCOM 16 - Saving, Printing EGC Messages Automatically

2. SYSTEM INITIALIZATION
2-15
2.4.4 Saving, printing EGC messages automatically
You may choose the EGC messages to save and print as follows:
Automatically saving EGC messages
1. Press the [F8] key to display the Setup menu.
2. Press the [5] key to display the Auto Mode Setup menu.
Auto Mode Setup
Auto Log Print OFF
Receive Alarm OFF
Auto Receive Message Save OFF
Auto Receive Message Print OFF
Data Report & Polling Print OFF
Auto EGC Message Save
Auto EGC Message Print
Auto EGC message save menu
3. Press the [↓] or [↑] key to choose Auto EGC Message Save and then press
the [Enter] key.
Auto Mode Setup
Auto EGC Message Save
System OFF
FleetNET OFF
SafetyNET (Routine) OFF
SafetyNET (Safety) OFF
SafetyNET (Urgent & Distress) ON
Auto EGC message print menu
4. Press the [↓] or [↑] key to choose message type and then press the [Enter]
key.
5. Choose ON or OFF as appropriate and press the [Enter] key to close the
window.
6. Press the [Esc] key three times to return to the standby display.