3. FILE OPERATIONS
3-4
3.2.3 Editor menu setup
The Editor menu sets the parameters of the text editor.
1. Press the [F8] key to display the Setup menu.
2. Press the [2] key to display the Editor Setup menu.
Setup
2. System Setup
3. Editor Setup
4. Terminal Setup
5. EGC Setup
6. Auto Mode Setup
7. E-Mail Setup
8. Directories
9. Configuration
Editor Setup
Ascii
Insert
ON
ON
4 Char
69
Block
Full Screen
File Edit Transmit EGC Reports Logs Options Setup Position StopAlarm
Text Mode
Edit Mode
Word Wrap
Line No.
Tab Width
Column Width
Cursor Type
Scroll
Editor setup menu
3. The illustration above shows the default editor setup settings. To change
settings:
a) Press the [↓] or [↑] key to choose item.
b) Press the [Enter] key to open corresponding options window.
c) Press the [↓] or [↑] key to choose setting.
d) Press the [Enter] key to register setting.
e) Press the [Esc] key twice to return to the standby display.
Text Mode: Choose “Telex” when creating a telex message. Only upper
case alphabet is permitted in telex. Use “ASCII” when
creating an e-mail message. Upper and lower case alphabet
may be used in an e-mail.
Edit Mode: Choose “Insert” (insert character at cursor location) or
“Overwrite” (write over character at cursor location).
Word Wrap: Turns on/off automatic hyphenation at the end of a line.
Line No.: Turns line number display on or off.
Tab Width: Sets horizontal tab width; two, four or eight tabs per line.
Column Width: Choose “69” for Telex or “40 to 80” for ASCII.
Cursor Type: Chooses cursor configuration, “
■“ or underline.
Scroll: Sets how much the screen moves up over the page (Full
Screen or Half Screen) when [PgUp] or [PgDn] key is
operated.
To Next Page
Loading...
Need help?
General
