Figure 8-3 Wearing an ESD wrist strap
⚫
Exercise caution when using tools.
⚫
If the installation position of the device is higher than the shoulders of the
installation personnel, use a vehicle such as a lift to facilitate installation. Prevent
the equipment from falling down and causing personal injury or damage to the
equipment.
⚫
The equipment is powered by high-voltage power sources. Direct or indirect
contact (especially through damp objects) with high-voltage power sources may
result in serious injury or death.
⚫
Ground the equipment before powering it on. Otherwise, personal injury may be
caused by high electricity leakage.
⚫
When a ladder is used, ensure that another person holds the ladder steady to
prevent accidents.
⚫
When connecting, testing, or replacing an optical cable, do not look into the
optical port without eye protection.
Equipment Safety
⚫
Use the recommended power cables at all times.
⚫
Use power cables only for dedicated servers. Do not use them for other devices.
⚫
Before operating equipment, wear ESD clothes and gloves to prevent
electrostatic-sensitive devices from being damaged by ESD.
⚫
When moving a device, hold the bottom of the device. Do not hold the handles of
the installed modules, such as the PSUs, fan modules, drives, and the mainboard.
Handle the equipment with care.
⚫
Exercise caution when using tools that could cause personal injury.
⚫
If the device is configured with active and standby PSUs, connect power cables
of active and standby PSUs to different power distribution units (PDUs) to ensure
reliable system operating.
⚫
Ground the equipment before powering it on.
Transportation Precautions
Improper transportation may damage equipment. Contact the manufacturer for
precautions before attempting transportation.
Transportation precautions include but are not limited to:
⚫
The logistics company engaged to transport the device must be reliable and
comply with international standards for transporting electronics. Ensure that the
To Next Page
Loading...
General