FusionServer 2288H V5 Server
Technical White Paper
Copyright © xFusion Digital Technologies Co., Ltd.
⚫
Off: The device is powered off or is faulty.
⚫
Blinking red at 1 Hz: A major alarm has been
generated on the system.
⚫
Blinking red at 5 Hz: A critical alarm has been
generated on the system.
⚫
Steady green: The device is operating
properly.
A non-maskable interrupt (NMI) is generally
triggered to stop the OS for debugging. To trigger
an NMI, press this button or click the button on
the iBMC WebUI.
NOTICE
⚫
Press the NMI button only when the OS is
abnormal. Do not press this button when the server
is operating properly. An NMI does not gracefully
shut down the OS and causes service interruption
and data loss.
⚫
Before pressing the NMI button, ensure that the OS
has the NMI processing program. Otherwise, the
OS may crash. Exercise caution when pressing this
button.
LOM port
connection
status
indicator
Each indicator shows the connection status of an
Ethernet LOM port.
⚫
Off: The network port is not in use or has
failed.
⚫
Steady green: The network port is properly
connected.
NOTE
⚫
The indicators correspond to two 10GE and two GE
network ports on the mainboard.
⚫
The LOM has a standby power supply and will not
be powered off even if the service system is
powered off. As long as the LOM ports are properly
connected to other working network devices, the
network ports will remain connected and the
indicators are on.
5.1.3 Ports
Port Positions
⚫
8 x 2.5" drive configuration
To Next Page
Loading...
General