FusionServer 2288H V5 Server
Technical White Paper
Copyright © xFusion Digital Technologies Co., Ltd.
⚫
Blinking green at 4 Hz: The firmware is being
upgraded online.
⚫
Steady green: The power input and output are normal.
⚫
Steady orange: The input is normal, but no power
output is supplied.
NOTE
The possible causes of no power output are as follows:
⚫
Power supply overtemperature protection
⚫
Power output overcurrent or short-circuit
⚫
Output overvoltage
⚫
Short-circuit protection
⚫
Device failure (excluding failure of all devices)
The UID indicator helps identify and locate a device.
⚫
Off: The device is not being located.
⚫
Blinking or steady blue: The device is being located.
NOTE
You can turn on or off the UID indicator by pressing the UID
button or remotely running a command on the iBMC CLI.
Data transmission
status indicator of the
management network
port
⚫
Off: No data is being transmitted.
⚫
Blinking yellow: Data is being transmitted.
Connection status
indicator of the
management network
port
⚫
Off: The network port is not connected.
⚫
Steady green: The network port is properly connected.
To Next Page
Loading...