FUTABA 3VCS - Page 41

42
Functions
TH.P=50%
TH.P=20% TH.P=80%
100% (full high)
50%
0% (neutral)
100% (full high)
20%
0% (neutral)
100% (full high)
0% (neutral)
80%
+1 ~ +100 (quick)
+1 ~ +100 (quick)
+1 ~ +100 (quick)
-1 ~ -100 (mild)
-1 ~ -100 (mild)
-1 ~ -100 (mild)
Throttle stick
forward saide
Throttle stick
forward saide
Throttle stick
forward saide
50% 20% 80%
Adjustment range
1: ~ 5 : 0 ~ 100%
F-TYP : EXP, VTR, CRV
BRAKE : -100 ~ 0 ~ +100%
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
Point in current setup
A vertical cursor line that shows the
point in the current setup is displayed
on the setup screen graph.
Returning entire curve to initial
value
- Select setup item "C:RES" and re-
turn the set value of each point to the
initial value by simultaneously press-
ing (approx. 1 sec) the (+) and (-) but-
tons.
For the CRV curve, only the high
side can be set. The brake be-
comes the EXP curve.
Throttle EXP/TH-EXP (Throttle system)
Adjustment method for CRV curve
(Preparation)
- Select "CRV" at setup item "F-TYP".
Setup items
1:~5 : Curve points 1~5
C:RES : Curve reset
F-TYP : Forward side curve selection
BRAKE : Brake side rate
Setup item switching
- Use the (DN) or (UP) button to switch the setup item.
1 Curve setup
Use the (DN) or (UP) button to select "1:" (1st
point), and use the (+) and (-) buttons to set the
1st point.
Set the throttle curve by sequentially setting "2:"
(2nd point) ~ "5:" (5th point).
2 Brake adjustment
Select setup item "BRAKE" by pressing the (DN)
button. When you want to quicken the rise, use
the (+) button to adjust the + side and when you
want to make the rise milder, use the (-) button to
adjust the - side.
3 When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.