EasyManuals Logo

FUTABA T6J User Manual

FUTABA T6J
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
position alarm mentioned above, the T6J will sound an audible warning and display a
visual warning on the screen also.
These warning signals will continue until the switch(es) are returned to their off
positions.
BATTERY CHARGING PROCEDURES AND PRECAUTIONS
          
NiCd/NiMH battery pack, both available separately. The transmitter batteries used are a matter of personal
preference.
AA Alkaline batteries are available at any local hobby shop, grocery store, etc. A NiCd/NiMH battery pack
will need to be purchased from a hobby shop.
Charging NiCd/NiMH batteries
As noted above, the T6J transmitter will function with four dry cell batteries, however, some modelers will
opt to purchase a NiCd/NiMH battery pack and charger for use with this transmitter.
Failure to exercise caution while using this product and to comply with warnings pertaining to the charging

Whether you choose NiCd (nickel cadmium, pronounced nI-kad) or NiMH (nickel metal hydride) batteries,
these packs require special care and charging. Read the charging instructions carefully.
NOTE: The batteries are generally supplied partially charged but will require a full, overnight charge before

1) With the transmitter power off, connect the transmitter charging cord coming from the A/C wall charger
to the charge jack in the right side of the transmitter case. The receiver charging cord may be connected to
the batteries two different ways: The charge cord may be connected directly to the battery pack, or to the
vacant charge connector (black) coming from the on/off switch in the model. Charging through the switch
is preferred as there will be no need to disconnect the battery.
2) Plug the A/C wall charger into a wall outlet. Note: If the wall outlet can be turned off by a switch in the

       
are being charged. Discharged batteries will take about 15 hours to fully charge. If using an aftermarket
 
not overcharge the batteries. NEVER charge the batteries at a rate higher than recommended by the
manufacturer. Depending upon the battery cell construction, the batteries should also be discharged

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUTABA T6J and is the answer not in the manual?

FUTABA T6J Specifications

General IconGeneral
BrandFUTABA
ModelT6J
CategoryRemote Control
LanguageEnglish

Related product manuals