63
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode. An audible double beep will be heard
and the default screen will change.
3) Press either the MODE key OR the END key to scroll through the function menus. Continue pressing the
MODE or END key until the hovering pitch curve (HOVP) menu appears on screen.
4) The right side of the LCD should indicate that the hovering pitch curve is inhibited,
prior to changing to ON.
or in both the NOR (normal) and Idle Up modes. Press the SELECT key one time
6) Press and hold END to exit the programming menu.
Fail Safe (F/S)-
Fail safe is the designation given to a safety feature which places a servo, or servos, to a preset position if the
RF signal is lost or interrupted. The use of the fail safe function is recommended from a safety standpoint.
Additionally, the T6J offers a battery fail safe function that brings the throttle servo down to its idle position
Normal Fail Safe Settings-
This menu offers two fail safe options when in the S-FHSS mode mode. Fail safe settings are not available
determined setting (position) should the RF signal be interrupted. If a predetermined setting is not
respective channel(s).
To Next Page
Loading...
Need help?
General
