EasyManuals Logo

FUTABA T6J User Manual

FUTABA T6J
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
38

The master channel, as the name suggests, is the channel that will be the controlling
channel. The slave channel, which will be determined in the next step, is the channel
that will be controlled by the master channel. That is, the slave channel will operate
based on input from the master channel.

(Slave) mixing. Then select the channel by pushing DATA INPUT lever. Channel 4

As noted above, the slave channel is the channel that follows the input control based
on the rates and input from the master channel.

INPUT lever to set the percentage of mixing. The available values range from

to move).
Note: Please ensure that you adjust the mixing for both travel directions. To reverse the mixing direction,


INPUT lever until the mixing value is -50%.
8) Push SELECT key to select the on/off switch (SW) and respective position. The
mixing may be controlled by the A, B or D switches, in either the Up or Down
position. Select the switch by pushing the DATA INPUT lever. Additionally, it is

9) Observe how the controls on the model respond to be certain you have achieved the correct mix and that
the throws are as desired.
10) Press and hold the END button to exit the programming menu.
Wing Type Selection- (ACRO only)
To ease the installation and set-up of the airplane, the T6J offers three different wing types to utilize: Normal,
        


for the respective aircraft.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUTABA T6J and is the answer not in the manual?

FUTABA T6J Specifications

General IconGeneral
BrandFUTABA
ModelT6J
CategoryRemote Control
LanguageEnglish

Related product manuals