41
surface.
7) Once the mix has been activated, move the servos to their full extremes to make certain they are not
overdriving the controls. If necessary, adjust the linkages to achieve the correct control throws.
8) Press and hold the END key to exit the programming menu.
Flap trim (FLTR)- (ACRO only)
#
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus.
on screen.
4) Push the DATA INPUT lever upward for approximately two (2) seconds. This will
the DATA INPUT lever upward or downward.
Note: When using switches A, B or D, it is possible to incorporate two rates- upward or downward.
Note:
and channel 6.
To Next Page
Loading...
Need help?
General
