How to fix a G-Tek CR-2010 PRO Measuring Instruments device with power but no display?
If your G-Tek Measuring Instruments device has power but no display, first, verify that the device switch is in the ON position. If it is, check the power supply at your location to ensure it's functioning correctly.
Why is my G-Tek CR-2010 PRO device not working on battery?
If your G-Tek Measuring Instruments device isn't working on battery, it could be due to several reasons. First, ensure the battery voltage is sufficient. Next, check the fuse to see if it's intact; use only a 0.5A fast blow 20mm fuse. Lastly, verify the battery polarity is correct.
What to do if G-Tek CR-2010 PRO Measuring Instruments display shows NAN after connecting sensor?
If the display of your G-Tek Measuring Instruments continuously shows 'NAN' after connecting the sensor, first, ensure the sensor is properly connected. Verify the sensor connection follows the specifications in TABLE 2. Also, confirm that the sensor type setting in the channel menu matches the type of sensor you are using.
Why is ink blotting on the paper of my G-Tek CR-2010 PRO?
If ink is blotting on the paper of your G-Tek Measuring Instruments, it might be due to chart absorbing moisture; put it in a desiccator to remove moisture. Alternatively, there might be excessive ink in the pen; put the pen on blotting paper for some time to remove the excess ink.
How to fix a pen that is not marking on G-Tek Measuring Instruments?
If the pen on your G-Tek Measuring Instruments is not marking, the pen may be dry; replace it. Also, check the pen arm pressure to ensure it's adequate.
What to do if my G-Tek CR-2010 PRO device is not working on battery?
If your G-Tek Measuring Instruments device isn't working on battery power, there are several things to check: * First, verify that the battery voltage is sufficient. * Next, inspect the fuse to ensure it's in good condition. Use only a 0.5A fast blow 20mm fuse. * Finally, confirm that the battery polarity is correct.
How to troubleshoot a G-Tek Measuring Instruments device with power but no display?
If your G-Tek Measuring Instruments device powers on but the display is blank, try the following: * Ensure the device switch is in the ON position. * Check the power supply at your location.
What to do if G-Tek CR-2010 PRO display shows NAN continuously after connecting sensor?
If the display of your G-Tek Measuring Instruments continuously shows 'NAN' after connecting the sensor, take these steps: 1. Verify that the sensor is properly connected. 2. Make sure the sensor connection matches the specifications in TABLE 2. 3. Adjust the sensor type in the channel menu to match the sensor you are using.
Why is the ink blotting on the paper of my G-Tek CR-2010 PRO?
If the ink is blotting on the paper of your G-Tek Measuring Instruments, consider these solutions: * If the chart has absorbed moisture, place it in a desiccator to remove the moisture. * If there's excessive ink in the pen, put the pen on blotting paper for a short period to remove the extra ink.
General| Resolution | 1 ppm |
|---|---|
| Sensor Type | Electrochemical |
| Weight | 150g |
| Connectivity | USB |
| Operating Temperature | 0°C to 50°C |
| Display | LCD |
| Data Logging | Yes |
| Alarm | Audible and visual alarms |
To Next Page
