GAT SMART.Lock 7000 System
www.gantner.com
HB_GAT-SMARTLOCK7000--EN_10
3
Copyright 2014, GANTNER Electronic GmbH, Schruns (Austria).
General warning and safety instructions
Dear customer,
We congratulate you on having selected a product (appliance or software) from GANTNER Electronic GmbH. Our aim is to ensure
that our product operates with safety and to your complete satisfaction. To achieve this aim please take this opportunity to familiar-
ise yourself with the following guidelines:
1. Installation, commissioning, operation and maintenance of the purchased product must be carried out in accordance with the
instructions, i.e., in accordance with the technical conditions of operation as described in the corresponding product documen-
tation.
2. Before installation, commissioning, operation, or maintenance it is therefore essential that you read the corresponding chapter
within this manual and observe its instructions.
3. If there are still some points on which you are not entirely clear, please do not take a chance. All queries can be clarified by
your GANTNER company representative or by contacting the GANTNER Electronic GmbH hotline.
4. Where not otherwise specifically documented, the appropriate installation, commissioning, operation, and maintenance of the
product is the customer’s responsibility.
5. Directly on receipt of the goods, inspect both the packaging and the product itself for any signs of damage. Also check that
the delivery is complete and includes all accessories, documentation, and auxiliary devices, etc.
6. If the packaging or product has been damaged in transport or should you suspect that it may have a fault, the product must
not be put into service. In this case, contact your GANTNER company representative. The representative will make every ef-
fort to resolve the problem as quickly as possible.
7. Installation, commissioning and servicing of our appliances must only be carried out by suitably trained personnel. In particu-
lar, electrical connections must only be made by correspondingly qualified specialists. All applicable installation provisions in
accordance with the relevant national Electrical Engineers construction regulations (e.g., ÖVE, [Austrian] VDE, [German]...)
must be observed.
8. Where not otherwise stated, installation and maintenance work on our appliances must be carried out when disconnected
from the power supply. This applies in particular to appliances which are normally supplied by low-voltage current.
9. It is prohibited to make alterations to the appliances, or to remove protective shields and covers.
10. Do not attempt to repair an appliance yourself after a defect, failure or damage, or to put it back into operation again. In such
cases, it is essential you contact either your GANTNER company representative or the GANTNER Electronic GmbH hotline.
11. GANTNER Electronic GmbH accepts no responsibility for any injuries or damage caused as a result of improper use.
12. Although every care is taken and we are continuously aiming for improvement, we cannot completely exclude the possibility
of errors appearing in our documentation. GANTNER Electronic GmbH therefore accepts no responsibility for the complete-
ness or the accuracy of this manual. The right is reserved to make alterations and we may carry out alterations at any time
without prior notice.
13. Should you discover any fault with the product or in its accompanying documentation, or have any suggestions for improve-
ment, you may confidently approach either your GANTNER company representative or GANTNER Electronic GmbH directly.
To Next Page
Loading...
Need help?
General
