GARO ENTITY PRO - Load Interface Installation Overview

102 pages

Save Page as PDF

To Next Page

To Previous Page

4.13.2 LOAD INTERFACE INSTALLATION OVERVIEW

CT1

CT2

CT3

Functional grounding of CT's

Indication light

HAN(RJ12)

Utillity Energy

meter

CT1-3: 0-333 mV output

HAN (RJ45)

Utillity Energy

meter

Ethernet

Connect to charging station,

other load interface

or network switch.

Wi-Fi antenna

FUNCTIONAL

BUTTON

GARO Entity Balance Basic

CT2-/GND(Black) L

CT1-/GND (Black) L

CT2+ (White) K

CT1+ (White) K

CT3-/GND(Black) L

CT3+ (White) K

46 Version: 1.3

Installation

Main Page

Table of Contents2
Introduction5
Document Description5
Product Description5
Feature Description5
Definitions5
Intended Use6
Contact6
Safety9
Safety Definitions9
Safety Instructions for Installation9
Product Overview11
Charging Station System Overview11
Charging Station Packaging Overview12
Product Variants13
Charging Station Overview15
Dimensions16
Single Version Installation Bracket (IB)16
Double Version Installation Bracket (IB)17
Installation19
To Do before Installation19
Personnel Requirements19
Personal Protective Equipment19
To Do a Plan for the Installation20
To Generate the Installation Code21
To Do a Check of the Delivery21
To Ensure the Necessary Tools21
To Ensure the Necessary Installation Material22
To Decide Internet Connection Type23
To Connect Several Charging Stations23
Before Setup23
Simple Setup Scenarios24
Connection Group Hierarchy24
To Decide the Position of the Charging Station26
Cable Installation26
To Install the Stickers for IT 230 V27
To Prepare the Installation Bracket for the Cable Installation27
To Install the Installation Bracket to a Wall28
To Prepare the Power Cable for Installation29
To Connect the Power Cable to the Terminal31
To Install a Second Power Cable (Daisy-Chaining Method)33
To Prepare the Installation Bracket with an Ethernet Cable33
To Prepare the Installation Bracket with a Second Ethernet Cable34
To Connect the Charging Station to the Internet with Communication Modem (Cat-M1/NB/GPRS)35
To Install the Control Cable to the Installation Bracket35
To Change the Position of the Type 2 Outlet or Fixed Cable36
To Do a Test of the Power Connection37
To Install a Protection Cover39
To Attach the Charging Unit to the Installation Bracket39
To Do a Final Functionality Test of the Product41
To Mount the Front Cover of the Charging Unit43
Dynamic Load Management (DLM)43
Dynamic Load Management (DLM) Functionality43
Load Interface Installation Overview46
To Install the Load Interface in an Electrical Cabinet50
GARO Connect56
The GARO Connect App56
GARO Connect App Process Overview57
GARO Connect App Symbols Overview58
Owner61
Installer68
Operation85
To Charge an Electrical Vehicle85
Indication Light86
To Schedule Charging87
To Stop the Charging of the Electrical Vehicle87
Maintenance89
To Clean the Charging Station89
To Do a Visual Check of the Charging Station89
To Do a Factory Reset89
To Do an Earth Fault Test89
To Do a Reset after a Minor Ground Fault90
To Do a Reset of a Tripped Circuit Breaker90
To Replace a Charging Unit91
PME - Protective Multiple Eathing (UK Versions Only)92
Service92
Repair92
Troubleshooting93
Technical Data95
Charging Station Technical Data95
Load Interface Technical Data97
Accessories98
Source Code99
EU Declaration of Conformity101

Other manuals for GARO ENTITY PRO

Installation And Operations91 pages

Installation2 pages

GARO ENTITY PRO - Load Interface Installation Overview

Table of Contents

Other manuals for GARO ENTITY PRO