You can also use the ICD2’s touch screen to perform these tasks starting with the Menu button.
Move the cursor to the Setup icon and press Enter.
Navigate to Surveillance>Record>Mainstream to setup the Analog channels (one through four).
To set up IP Channel navigate to Surveillance>IPC Setup.
To set Vehicle ID, navigate to Basic Setup>Regist Info>Vehicle Info.
After setting the configurations, with the Hard Drive inserted, access the Setup menu. Navigate
to Setup>Maintenance>Storage to format the Hard Drive.
Please note: non-Gatekeeper branded Hard Drive may not function reliably. If used, non-
Gatekeeper branded Hard Drive must be formatted in the Y58 prior to use.
Start the vehicle, and wait for the recorder to boot up (approximately two minutes). Confirm
live camera video is visible on the monitor (small Green camera in each camera image –
indicates the Y58 is recording).
Confirm Y58 is recording by observing the LED as per the following table.
Note: The NET status LED is currently not supported.
To access the Caddy, turn key to the unlocked position, wait for the LEDs to turn off, and pull the Caddy
out.
To Next Page
Loading...