Gatekeeper Y58 - Page 46

Y58 User Manual & Install Guide
46 of 148
Notes: channel no 7 and 8 are for IP cameras.
Enable
For channels 1 to 6, only enable the channels
which actually have cameras connected. Please
note that the system will show a video loss
message on channels which are enabled, but
do not have a connected camera (i.e., no
incoming video stream).
Likewise, for channel 7 and 8 (Digital IP Camera
channel), only enable this channel if it actually
has a camera connected.
Resolution
For channels 1 to 6 (Analog camera channels)
DEFAULT SETTINGS:
D1 resolution.
For channels 7 – 8 (IP cameras)
DEFAULT SETTINGS:
720
Frame Rate
DEFAULT SETTINGS:
15
Quality
DEFAULT SETTINGS:
1 (Best)
Record Mode
DEFAULT SETTINGS:
Power Up
Audio
DEFAULT SETTINGS:
Always Audio
Alarm Quality
DEFAULT SETTINGS:
1 (Best)
Encode Mode
DEFAULT SETTINGS:
CBR
Audio Coding Format
DEFAULT SETTINGS:
ADPCM
Note – Click on the “?” to get more information
about the audio coding format.
Dual Stream
Storage Dual Stream
Recording
DEFAULT SETTINGS:
Checkbox – Unselected