GE Interlogix 60-792-01-95R - Superbus 2000 RF Receiver (60-764-01-95 R-16 Z;32 Z;MAX); Superbus 2000 Phone Interface;Voice Module (60-777-01)

17
• One SuperBus 2000 RF Receiver can be installed inside the cabinet, but it must be mounted
on the right-hand side to accommodate the antennas (see Figure 22). Additional receivers
must be installed outside the cabinet.
Figure 22. Installing the Support Standoffs and Mounting SuperBus 2000 Modules Inside the
Cabinet (RF Receiver Shown)
SuperBus 2000 RF Receiver (60-764-01-95R-16Z/32Z/MAX)
1. Mount the receiver inside the cabinet enclosure as shown in Figure 22.
2. Connect the receiver to the panel as shown in Figure 23.
SuperBus 2000 Phone Interface/Voice Module (60-777-01)
The Phone Interface/Voice Module includes two backplates for mounting the module inside the
control panel cabinet. The module can also be mounted outside of the control panel using an
optional plastic housing (part no. 60-800). Refer to the SuperBus 2000 Phone Interface/Voice
Module Installation Instructions included with each module, for complete mounting instructions.
Note
In UL Listed installations, the
Phone Interface/Voice Mod-
ule is for supplementary use
only.
The module requires panel power and bus connections, phone line connection through panel ter-
minals and DB-8 cord (from an RJ-31X jack), and speaker connection through panel terminals.
Wiring—Power
Connect the module to the panel power and bus terminals as shown in Figure 24.
Note
For RJ-31X connections,
see “Installing an RJ-31X
Phone Jack (13-081).
Wiring—Phone Line
For partition 1, connect the phone line to the module through the panel terminals and DB-8 cord
(from an RJ-31X jack) as shown in Figure 25. For partition 2 phone connection, see the Super-
Bus 2000 Phone Interface/Voice Module Installation Instructions.
6 0 7 3 4 g 1 0 7 d . d s f
Support
Support Standoff
Standoffs
Side
Mounting
Clip
Panel
Cabinet
RF
Receiver
Module
(Cover
Removed)
Top
Mounting
Clips (6)
GND +12V A BBUS
+12V A B GND
3
4
5
6
Panel
Terminals
Receiver Module
Terminal Strip
Figure 23. Connecting the SuperBus 2000
RF Receiver to the Panel Terminals
6 0 7 3 4 1 0 8 d . d s f
1
+ 1 2 V
2
A
3
B
4
G N D
5
G N D
6
S P K 1
7
S P K 2
8
A U D 1
9
A U D 2
1 0
G N D
1 1
T I P 1
1 2
T I P 2
1 3
R I N G
2
1 4
R I N G
1
3 4 5
6
+ 1 2 V
A
B
G N D
B U S
Panel Terminals
Phone Interface/Voice
Module Terminal Strip 1
Phone Interface/Voice
Module Terminal Strip 2
Figure 24. Connecting the Phone Interface/Voice
Module to the Panel Power and Bus Terminals