29
Note
To use this feature, the
Duress Option setting under
the
reporting—partition 1 (2)
menu must be turned on.
¾To program a Duress Code:
With the display showing DURESS CODE ****, enter the desired 4-digit duress code. The dis-
play flashes the entered setting. Press # and the display shows the new code.
¾
To delete a Duress Code:
With the display showing DURESS CODE nnnn (current code), press D. The display shows
DURESS CODE ****.
Phones Menu
The PHONES menu lets you set up central station reporting for the system. The following
describes how to program the settings that appear under
CS PHONE 1-3.
Phone Number (Phones—CS Phone 1-3)
(cs phone 1: 0100, cs phone 2: 0110, cs phone 3: 0120)
(Default = none) This setting is used for programming the central station receiver phone number.
Phone numbers can be 1 to 24 digits long, including pauses or * and # characters.
To enter pauses, press C.
To enter *, press and hold 7 for about two seconds.
To enter #, press and hold 9 for about two seconds.
Note
The
PHONE NUMBER menus are
not accessible if a Dealer
Code is programmed and
the Installer Code is used to
enter installer programming
mode. To access these
menus when a Dealer Code
is programmed, you must
enter installer programming
mode using the Dealer
Code.
Call-waiting services should
be disabled to prevent inter-
rupting panel communica-
tion to the central monitoring
station. To program a dialing
prefix that disables call-wait-
ing, see the Call Wait Cancel
setting under the menu
PHONE OPTIONS—GLOBAL.
¾To program a Central Station Phone Number:
With the display showing PHONE NUMBER _ (or current number), enter the desired phone
number. The display flashes the entered number. Press # and the display shows the new
number.
¾
To delete a Central Station Phone Number:
With the display showing PHONE NUMBER (current number), press D. The display shows
PHONE NUMBER _.
High Level Rpts (Phones—CS Phone 1-3)
(cs phone 1: 0101, cs phone 2: 0111, cs phone 3: 0121)
(Defaults: CS Phone 1 = on, CS Phone 2 and 3 = off) When this setting is on, the following con-
ditions report to the central station:
• Fire, Police, Auxiliary, and Duress alarms
• No Activity
• Receiver Failure (or jam)
• Tamper conditions, including Zone Tampers and System Tamper (40 incorrect key presses or
touchpad supervisory)
• Entering or exiting Sensor Test mode
• Phone Test
¾
To turn High-Level Reports off or on:
With the display showing HIGH LEVEL RPTS OFF/ON (current setting), press 1 (off) or 2 (on).
The display flashes the entered setting. Press # and the display shows the new setting.
Low Level Rpts (Phones—CS Phone 1-3)
(cs phone 1: 0102, cs phone 2: 0112, cs phone 3: 0122)
(Defaults: CS Phone 1 = on, CS Phone 2 and 3 = off) When this setting is on, the following non-
alarm conditions report to the central station:
•Force Armed
• Hardwire Zone Trouble (open or short)
• Supervisory (wireless devices)
• Low Battery (wireless devices)
• Phone Test
• Other non-alarm related conditions
¾
To turn Low-Level Reports off or on:
With the display showing LOW LEVEL RPTS OFF/ON (current setting), press 1 (off) or 2 (on).
The display flashes the entered setting. Press # and the display shows the new setting.
To Next Page
Loading...
