23
Note
If the system is powered up
after the programming
touchpad is connected or if a
bus command scan is exe-
cuted, the programming
touchpad will be “learned”
into the system and must
later be manually deleted.
¾To enter program mode:
1. Make sure the system is disarmed in all partitions.
2. Press 8 + 4321 + 0 + 0. The display shows
SYSTEM PROGRAMMING.
¾
To enter programming mode using a programming touchpad:
1. Connect the red, black, green, and white wires from the Programming Touchpad Cable
(60-791) to the power and bus wires on an alphanumeric touchpad, matching the wire colors
on each.
2. Make sure the system is powered up and disarmed.
3. Connect the plug on the cable onto the panel programming touchpad header (see Figure 38).
4. Press 8 + 4321 + 0 + 2. The touchpad sounds one short beep. Press * and verify that the dis-
play shows
SERVICE TOUCHPAD ACTIVE.
5. Press 8 + 4321 + 0 + 0 and the display shows SYSTEM PROGRAMMING.
6. After programming is completed, simply disconnect the touchpad from the panel header.
Figure 38. Connecting a Programming Touchpad
Touchpad Button Programming Functions
In program mode, touchpad buttons let you navigate to all installer programming menus for con-
figuring the system. Table 6 describes the touchpad button functions in program mode.
Moving Through Program Mode Tiers and Menus
There are two basic tiers of programming menus. Tier 1 menus are accessible immediately after
entering program mode (see Figure 39).
Table 6: Touchpad Button Functions
Button Programming Function
#
Selects menu item or data entry.
*
Deselects menu item or data entry (if pressed before #).
A & B
Scroll through available options at the current menu tier. Also scroll through sen-
sor text options during sensor text programming.
C
Enters pauses when programming phone numbers.
D
Deletes certain programmed settings.
0 thru 9
Enter numeric values wherever needed.
1 & 2
Select off (1) or on (2) wherever needed.
1 thru 6
Press and hold to enter alphabetical characters A thru F for account numbers.
7 & 9
Press and hold to enter * (7) or # (9) for phone numbers.
6 0 7 3 4 G 3 0 8 D . D S F
S t a t u s
F e a t u r e s
p r e s s b o t h
L i g h t s
S y s t e m
A w a y
P a g e r
O f f
N o D e l a y
p r e s s b o t h
p r e s s b o t h
T e s t S y s t e m W e e k l y
S i l e n t
S t a y
D
*
7
0 #
8
B
A
4
1
5
6
2
3
B y p a s s
M e n u
C
9
Programming
Touchpad
Cable (60-791)
To Next Page
Loading...
