56
Partition Master (User Codes—Partition Master Code)
(partition 1: 0310, partition 2: 0311)
(Default = none) The Partition Master Code provides access to all system operations and user
programming for a single partition.
Note
You must be “in” the partition
of the partition master code
you wish to change.
¾To change the Partition Master Code:
1. With the display showing USER CODES, press # then A or B until the display shows PARTI-
TION MASTER CODE
.
2. Press # and the display shows PARTITION nnnn (current code).
3. Enter a new 4-digit code. The display flashes the entered code. Press # and the display shows
the new code.
System Master (User Codes—System Master Code)
(0320)
(Default = 1234) The System Master Code provides access to all system operations and user pro-
gramming.
¾
To change the System Master Code:
1. With the display showing USER CODES, press # then A or B until the display shows SYSTEM
MASTER CODE.
2. Press #
and the display shows SYSTEM MASTER nnnn (current code).
3. Enter a new 4-digit code. The display flashes the entered code. Press # and display shows the
new code.
Options Menu
The OPTIONS menu lets you set up the system for downloading and silent arming. You can also
adjust alphanumeric touchpad display brightness from this menu.
Downloading (Options)
(040)
(Default = on) When this setting is on, the panel can communicate with ToolBox
®
software for
programming the system from off-site.
Note
For this feature to work, the
panel must be connected to
a phone line and be pro-
grammed with REMOTE
ACCESS on, with a Down-
loader phone number, and
with a Downloader code.
¾To turn Downloading off or on:
1. Press A or B until the display shows OPTIONS.
2. Press #, then A or B until the display shows DOWNLOADING OFF/ON (current setting).
3.
Press 1 (off) or 2 (on). The display flashes the entered selection. Press # and the display shows
the new setting.
Silent Arming (Options)
(041)
(Default = off) This setting determines whether or not the panel sounds status beeps from sirens
and the touchpad when the system is armed.
Note
When this feature is on, the
user does not need to press
5 (SILENT) before arming
the system to prevent status
sounds.
¾To turn Silent Arming off or on:
1. Press A or B until the display shows OPTIONS.
2. Press #, then A or B until the display shows
SILENT ARMING OFF/ON (current setting).
3. Press 1 (off) or 2 (on). The display flashes the entered selection. Press # and the display shows
the new setting.
Touchpad Brightness (Options)
(042)
(Default = 2) This setting lets the user lighten or darken the background on touchpad displays.
Each touchpad can be set to compensate for lighting conditions in the touchpad location.
¾
To adjust Touchpad Brightness:
1. Press A or B until the display shows OPTIONS.
2. Press #, then A or B until the display shows TOUCHPAD BRIGHTNESS n (current setting).
3.
Enter a setting from 0 (darkest background) to 3 (brightest background). The display flashes the
entered selection. Press
# and the display shows the new setting.
Volume (Options)
(043)
(Default = 4) This setting determines the volume level of status sounds from speakers connected
to the Phone Interface/Voice Module.
To Next Page
Loading...
