Simon XT
Installation Manual
40
Learn sensor
To learn a sensor:
1. Press the scroll buttons until the panel displays System programming.
2. Press Enter. The system prompts for an access code.
3. Enter the dealer or installer code and press Enter. The panel displays Access Codes.
4. Press the scroll buttons until the panel displays Sensors.
5. Press Enter. The panel displays Learn sensor.
6. Press Enter. The panel displays Trip sensor ##, with the number signs flashing.
Note: If you wish to use a sensor number other than the next one available, use the number keys to enter a two-digit
sensor number immediately.
7. Press the sensor program button or release the sensor tamper switch. The panel displays Sn ## Grp 10
<Front Door>, with the Grp 10 flashing. Use the number or scroll buttons if you want to enter a new
group number; press Enter to accept the group number displayed.
8. The sensor text is now flashing. Use the scroll buttons to scroll through the text list or enter the three-
digit shortcut. Press Enter to accept the first text segment. You may enter more text or press Enter
again to finish adding the sensor.
9. The panel displays Trip Sensor ## (with the next available sensor number). Press STATUS repeatedly
to exit.
Deleting a sensor
To delete a sensor:
1. Press the scroll buttons until the panel displays System programming.
2. Press Enter. The panel displays Enter Code.
3. Enter your access code and press Enter. The panel displays Access Codes.
4. Press the scroll buttons until the panel displays Sensors.
5. Press Enter. The panel displays Learn sensor.
6. Press the scroll buttons until the panel displays Delete Sensor.
7. Press Enter. The panel displays Sn ## Grp ## <Text>.
8. Press the scroll buttons until the panel displays the sensor you want to delete.
9. Press Enter. The panel displays Deleted, then shows Delete Sensor.
10. Press STATUS twice to exit.
To Next Page
Loading...
Need help?
General
