GE Security Simon XT Installation Manual

Chapter 4
Programming
53
Resetting memory to the factory defaults
To reset the panel to its factory defaults, do the following:
1. Open the panel cover.
2. Unplug the transformer and disconnect the battery.
3. Press and hold the four arming/status buttons (DOORS+WINDOWS, MOTIONS, DISARM, and
STATUS) on the front of the panel and the tamper switch on the inside of the panel (see Figure 5 on
page 20).
4. Restore power to the panel with the battery while holding the four buttons and tamper switch.
5. Release the buttons.
6. Plug in the transformer to the outlet.
Note: The procedure to reset memory to factory defaults is meant to be difficult. It is also possible to restore power to the
panel by plugging in the transformer first, which allows the panel to be closed so that the tamper switch does not need
to be pressed. If you do this, be sure to reconnect the battery.
Program the panel in this order:
1. Set the panel clock.
2. Add (learn) sensors.
3. Set the housecode and light and appliance controls (entry/exit activated lights, sensor-activated lights,
time-activated lights).
4. Change options as needed.
Note: If phone lock is on, phone numbers 1 and 2, downloader phone number, account number, phone lock, downloader code,
phone report mode 1, phone report modes 1 to 4, access code length, and call waiting and dealer code will not reset to
their defaults.

GE Security Simon XT Specifications

General

Brand	GE Security
Model	Simon XT
Category	Security System
Language	English