6.4 Monitor the run
Introduction
You may follow the on-going method run in the System Control module. The current
system status is shown in the System state panel in the Run Data pane. For example,
it may state Run, Wash or Hold.
See Section 3.2.2 The System Control module, on page 53 for information about the data
shown in System Control during a run, the layout of the module and the procedure to
customize the view of the different panes.
Process picture
The Process picture pane displays the current flow path during the run and can be used
to control the run. Color indication is applied, as shown in the table below. Real-time
data from monitors are also displayed in the process picture. See illustration below.
IndicationColor
Open flow path with flowGreen
Closed flow path or an open path without flow.Grey
ÄKTA pure Operating Instructions 29022997 AF 127
6 Run a method
6.4 Monitor the run
To Next Page
Loading...
