System Control toolbar buttons
The following table shows the System Control toolbar buttons that are referred to in this
manual.
FunctionButtonFunctionButton
Run. Starts a method run.Open Method Navigator.
Opens the Method Naviga-
tor where available meth-
ods are listed.
Pause. Suspends the
method run and stops all
pumps.
Hold. Suspends the method
run, while current flow rate
and valve positions are
sustained.
End. Permanently ends the
method run.
Continue. Resumes for ex-
ample a held or paused
method run.
Connect to Systems. Opens
the Connect to Systems di-
alog box where systems
can be connected, and cur-
rently connected users are
displayed.
Customize. Opens the Cus-
tomize dialog box where
curve settings, run data
groups and run log con-
tents can be set.
54 ÄKTA pure Operating Instructions 29022997 AF
3 System description
3.2 UNICORN software
3.2.2 The System Control module
To Next Page
Loading...
