Connect the sensors
Step Action
1 Connect the A
E-151 air sensor to cables from the cable gland located on
the inlet side of the system cabinet.
2 Connect the three pressure cells (P
E-111, PE-112, and PE-113) with ca-
bles from their respective cable glands (A, B, and C) on the front and inlet
(right) side of the system cabinet.
5 Preparation
5
.2 Install disposable flow kits
120
ÄKTA ready XL Operating Instructions 29281616 AE
*** TeDIS Valid on Date Printed Printed on: 15-09-2023 11:27:35 ***
To Next Page
Loading...
