6.6 Repair and calibration
Introduction
This section describes component checks, repair and calibration of components other
than the pH probe that the user can perform without GE Healthcare support. Calibration
of the pH probe is described in Section 6.5 Calibration of pH probe, on page 148.
Procedures can also be found in the respective product manuals provided in the product
documentation package.
Components not covered in this manual may not be calibrated or repaired by the user.
If any such components of ÄKTAprocess do not operate according to specifications,
contact your GE Healthcare representative.
WARNING
Do not attempt to perform any actions not described in these
documents.
Always contact your GE Healthcare representative for advice if
such a need should arise.
In this section
This section contains the following subsections:
See pageSection
1526.6.1 Pump calibration
1536.6.2 Air trap calibration
1566.6.3 Component replacement
ÄKTAprocess Operating Instructions 29-0252-49 AA 151
6 Maintenance
6.6 Repair and calibration
To Next Page
Loading...
