GE AKTAprocess - Cleaning-In-Place (CIP); CIP Hookup

6.2.2 Cleaning-in-place (CIP)
Introduction
This section provides general information about the CIP procedure, and provides some
general guidelines for CIP procedures. For a detailed instruction, refer to Section 6.2.3
General procedure for CIP and sanitization, on page 141.
CIP hook-up
During the CIP procedure, the column can be replaced with a bypass manifold or spool
piece.
Refer to the column instructions for column specific cleaning recommendations.
138 ÄKTAprocess Operating Instructions 29-0252-49 AA
6 Maintenance
6.2 Cleaning
6.2.2 Cleaning-in-place (CIP)