GE AquaTrans AT868 - Entering Global System Data - GLOBL-SYSTM

September 2004
2-22 Programming Site Data
Entering Global System
Data - GLOBL-SYSTM
While completing these instructions, refer to Figure A-2 in
Appendix A, Menu Maps. Remember to record all programmed data
in Appendix C, Data Records.
Use the steps below to enter system information in the GLOBL menu.
Selecting the GLOBL-
SYSTM Units
1. Press [ESC], [ENTER], [ESC]. The meter enters the user program.
2. Press [
X] until PROG appears and press [ENTER].
3. Press [
X] until GLOBL appears and press [ENTER].
4. Press [
X] until SYSTM appears and press [ENTER].
5. Enter a short message up to 16 characters by using the arrow keys.
Press [
W] and [X] to move the cursor to desired location and
press
[S] and [T] to select the desired letter/space/symbol and
press [ENTER].
Selecting the System
Units
1. Press [X] to select the system units and press [ENTER].
For single-channel units, go to step 6 on page 2-23. For 2-channel/
path units, proceed with the following steps.
2. Press [
X] to select the volumetric units for the flow rate display
and press [ENTER].
3. Press [
X] to select the number of digits to the right of the decimal
point in the volumetric flow rate display and press [ENTER].
4. Press [
X] to select the desired units for the totalized flow rate
display and press [ENTER].
5. Press [
X] to select the desired number of digits to the right of the
decimal point in the totalized flow rate display and press [ENTER].